MONITOR water temperature with thermometer.Ignore readings other than sanitizer at this time, as they may be compromised by high sanitizer levels. If lower, repeat steps 8 through 10 until desired result is obtained. Sanitizer level should be at least in the “IDEAL RANGE” or higher. AFTER 10 minutes or at the end of the “CLEAN” mode, use the test kit or test strips to check sanitizer level.NOTE: On spas equipped with multiple jet pumps and multiple “SMARTJET” levers, these systems must also be used or the distribution is only partially done. Return the “SMARTJET” lever to the 3 o’clock (primary) position when complete. a. DISTRIBUTE the sanitizer throughout the spa by rotating the “SMARTJET” lever through the 3 o’clock, 6 o’clock, 9 o’clock, and 12 o’clock positions, pausing for at least one minute in each position.Engage the “CLEAN” mode and add chemicals through the filter area. SANITIZE the spa by adding 1-1/2 teaspoons of chlorine / bromine per 250 gallons of spa water.This is easily done on spas equipped with a “CLEAN” mode by pushing required buttons. IMPORTANT: Add spa water chemicals directly into the filter compartment with jet pump on high speed for at least 10 minutes. These adjustments are important, as water balance will prevent the sanitizer from operating effectively. a. These procedures are listed on the water analysis obtained from our LAB. ADJUST Total Alkalinity, Calcium Hardness, and pH.On 230V models, reset the 30AMP Breaker inside the sub panel box to start heater. Set temperature to 102° Fahrenheit or desired temperature.NOTE: Weak or surging jets are an indication of a low water condition, clogged filters, or a sticking skimmer assembly. Once the jet system is fully operational, priming of the spa is complete. PURGE air from the plumbing by turning the jets on for one minute.On 220V models, reset the 20AMP Breaker inside the sub panel box. On 115V models, plug in and push the RESET button on the GFCI plug. FILL spa until water level is either: 1/3 way up tile up to water imprint covers all jets completely plus an inch or touching the bottom of the pillows.Fill spa by placing hose inside filter standpipe. CLOSE and cap all drains and remove GRAY Filter retaining cap on spa filter.Flush garden hose for 30 seconds to remove stale water.DO NOT use your spa until it has been sanitized as described in steps 8 -11.DO NOT fill the spa with Hot water! Tripping of the high limit sensor may result.The following instructions must be followed to ensure a successful start-up or refill: Cautions:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |